# # SPiDBoot configuration file # # (c) 2004-2005 SPiDCOM Technologies # # Select the RAM device you want to use # Commenting this line will select the default device # for each platform DFT_RAM_BRAND=DEFAULT DFT_RAM_TYPE=DEFAULT_TYPE DFT_RAM_SPEED=C DFT_RAM_SIZE=16 # Comment this if INTEL/SHARP command set flash device support is not needed USE_INTEL_CMDSET # Comment this if AMD/FUJITSU (SPANSION, MACRONIX, ...) command set flash device support is not needed USE_AMD_CMDSET # Comment this if the NVRAM block is not used or is not to be protected USE_NVRAM # Comment this if boot statistics (boot count, manual reset, failure reset) are not needed # USE_BOOTSTATS # Comment this if no CRC check is needed USE_CRC # Comment this if no image uncompression is needed USE_ZLIB # Comment this if no Hex image format support is needed USE_HEX # Comment this if no Elf image format support is needed USE_ELF # Comment this if the Command-line interface is not needed # USE_CLI # Comment this if the standard C library is not to be used # all the previous options will be suppressed. USE_STDIO # Comment this if the Serial port is not needed # all the previous options will be suppressed. USE_SERIAL # Comment this if only one software image is to be managed # The image is supposed to be binary USE_IMAGE_TABLE # This address will only be used if the USE_IMAGE_TABLE item is commented. # This address indicates the location of an image descriptor that enables # the software to run the image # This descriptor must reside in flash memory (0x08000000-...) IMAGE_DESC_ADDR=0x080b0000