|author||Nicolas Schodet||2008-04-20 19:17:57 +0200|
|committer||Nicolas Schodet||2008-04-20 19:17:57 +0200|
- added parameters measure documentation.
Diffstat (limited to 'digital/asserv')
1 files changed, 81 insertions, 0 deletions
diff --git a/digital/asserv/doc/parameters.txt b/digital/asserv/doc/parameters.txt
new file mode 100644
@@ -0,0 +1,81 @@
+ How to measure robot parameters?
+The scaling factor will be used to convert between asserv steps and
+millimeters. We will look at the left counter as this one is not corrected.
+Select a flat, clean and long (2 to 10 meters) surface, then position the
+robot precisely on a starting line. Draw a parallel line at the other end and
+measure distance between the two lines.
+Now, reset the robot counters and start monitoring left counter value. Drag
+the robot as linearly as possible until it reaches the final line. While
+doing this, remember any counter overflow or try to calculate how many
+overflow is expected (with a wheel diameter estimation).
+Position precisely the robot on the finish line and write down the left
+The scaling factor is given by::
+ distance (mm) / augmented_counter
+where ``augmented_counter`` is the counter value prefixed with the number of
+Keep the right counter value as well as it can be used for the next measure.
+Right wheel correction
+As wheels can not be exactly the same, we will introduce a correction factor.
+Do the same measure as for the scaling factor, but we need the left and right
+The correction factor is given by::
+ left_augmented_counter / right_augmented_counter * 2^24
+The ``2^24`` factor is used to have a 24 bit floating point number.
+Now, it is time to check your measures. Ask the robot to drive a distance and
+This is the distance between the encoders wheels, used to compute robot angle.
+Place the robot precisely on a line.
+Now, reset the robot counters and start monitoring counters values. Make a
+large number of turns (about 10) and position the robot precisely on its
+starting line. While doing this monitor counting direction, and any counters
+overflow or underflow.
+Write down the counters values and the number of overflow.
+A counter was counting backward, so you will have to handle negatives numbers.
+For example, if the current counters values are 0x1234 and 0x2345, if the
+first counter was counting upward and the second one backward, and each
+counter has overflowed 3 times, this gives, in the 24 bit two's complement
+notation, 0x031234 and 0xfc2345 (0xfc = 0xff - 3). The second number
+represents -0x03dcbb (0x1000000 - 0xfc2345).
+Now make the difference between the two augmented counters values, or the sum
+of their absolute values, this will give the total distance in steps travelled
+by the two encoders to do the number of turns.
+The encoders footing is given by::
+ difference / 2 / pi
+The ``2`` divider is there because we summed the distance traveled by both
+encoders. Then we divide by ``pi`` to get the diameter.